How To Light A Gas Fireplace With Igniter. Next up, turn the control of the gas until the setting of the pilot aligns to the mark located on the outer rim of that control. Ignite gas logs for fireplaces near the knob for on and off there is an orange or black button, approximately 3/4 of an inch that is labeled “igniter” that simply pushes in the same way as the.
Bought a new home with a vented gas fireplace. The pilot will light the gas and then the entire fireplace will be operational. A clockwise turn will make the flame smaller and the counterclockwise turn will increase it.
With That Said, You Can Always Light A Gas Fireplace By Holding The Pilot Light Down And Lighting A Match.
Turn the control of the gas. Check for any apparent damages to the pipes. How to light a gas fireplace with igniter.
Push In The Pilot Knob, Which Will Then Manually Send Gas Into The System.
If after pushing the button the pilot does not light, wait for about 10 seconds before you push the button in again. A gas fireplace control panel usually has a red igniter pilot knob and a control dial. A gas fireplace pilot light is a small part that can be found as part of the ignition system for the fireplace and creates a smaller flame that’s used to help light the main flames generated by the larger burner.
Here Are The How To Steps Required To Manually Light Your Legend Valor Gas Fireplace Pilot Light.if You're Having Problems With Remote Ignition, There’s P.
If the fireplace hasn't lit up within 10 seconds, wait at least 10 seconds before trying again. Make sure that you push that button in while pushing the starter. A gas fireplace control panel usually has a red igniter pilot knob and a control dial.
Chick Ignition If Gas Fireplace Will Not Ignite.
The first think you want to do is pull the cover off the fireplace. While pressing down the control knob in the pilot position, press the ignition switch. Depending on how long it’s been since the gas fireplace was last used, ignition may take several attempts before igniting.
If You Release The Knob And The Clicking Stops, You Will Need To Hold The Ignition Knob In Until You See Flames Begin To Catch Along The Gas Line Under The Logs Or Tempered Glass Beads.
Turn the knob to the on position. This pilot flame is required every time when lighting the main burner flames in a gas fireplace. Light a match or butane candle lighter and hold it near the burner in the fireplace.